Industrial valve and pipe installation instructions

1. Weld the flange to the pipe and cool it to ambient temperature before
installing the valve onto the flange. Otherwise the high temperatures generated
by the weld can affect the performance of the resilient seat.

2. The edge of the welded flange must be machined to a smooth surface to
avoid damage to the resilient seat during valve installation. The surface of the
flange must be completely free from damage and deformation, remove all dirt and
foreign matter, and avoid liquid leakage at the valve and flange interface.

3. Clean the flange and the inner cavity of the pipe to completely remove the
splashes, peeling scale and other foreign matter left by the welding.

4. When installing pipes between valves, precisely aligning the center of the
upper and lower water pipes is critical for trouble-free operation. The
inaccurate center point must be avoided.

5. When installing the valve, set the positioning bolts under the pipe to the
same height to support, and adjust the distance between the flanges until the
sides of the valve body are about 6-10 mm apart. Remember that the valve can
only be opened from the closed position to a 10° position.

6. Insert the two bolts into the lower guide rod of the valve and carefully
install them so that the flange surface does not damage the resilient seat.

7. Then place the other two bolts into the guide rod above the valve to
ensure accurate center position between the pipe and the valve.

8. Open the valve three times to check whether there is poor contact between
the valve plate and the flange or not.

9. Remove the positioning bolts and place all bolts around the body for
alternate diagonal tightening until the flange touches the valve body. Please
refer to the table below for the recommended torque values.

10. Provide a support for the valve when installing the actuator to avoid
distortion of the valve neck and reduce friction between the valve and the
pipe.

11. Do not step on the valve neck or valve handwheel.

12. Do not reverse the installation of valves of the DN350 or larger.

13. Do not install the butterfly valve directly on the check valve or pump,
as this may cause damage when contacting the valve plate.

14. Do not install the valve on the downstream side of the elbow and the
reducer, or calibrate the valve as the flow rate changes. In this case, it is
recommended to install the valve at a distance of approximately 10 times the
nominal diameter of the valve.

15. Installation of the valve requires consideration of which valve plate
will experience the effects of flow rate and pressure during liquid
transport.

www.zhonggongtemetal.com
Jiangsu Zhonggongte Metallurgical Technology Co., Ltd.

  • Related Posts

    Jinko Mono Solar Panels vs. Bifacial Solar Panels: Which Should You Choose?
    • adminadmin
    • November 20, 2026

    Choosing the right solar panels is an important decision for solar distributors, EPC contractors, project developers, and commercial property owners. With the continuous development of photovoltaic technology, buyers now have access…

    Continue reading
    Lucky Star Energy Group’s Robot Battery Pack: Technical Analysis of Innovation
    • adminadmin
    • November 19, 2026

    Lucky Star Energy Group recently presented a technical overview of its advanced robot battery pack in Shenzhen. During the presentation, the company's engineering team discussed how improvements in power management,…

    Continue reading

    Leave a Reply

    Mechanical Equipment & Tool Parts

    CNC Machining Services for Performance Hardware Brands, 2026

    • November 20, 2026

    Shenzhen Servo Motor Driver Manufacturer CNC Machining 2026

    • November 20, 2026

    CNC Machining Service Pricing and NDA Protection Explained

    • November 20, 2026

    Sports Lighting Energy Management: How to Reduce Operating Costs Without Compromising Lighting Quality

    • November 20, 2026

    Which HVDC Suppliers Balance Efficiency And Lifecycle Cost

    • November 20, 2026

    Aokai 10 mg Filter Bags: Baghouse Emission Control Quotes

    • November 20, 2026